1.Product introduction
Natural Gas---its main component is CH4,which takes 90% of the whole content.Thermal efficiency of conversion is 65%, which is same to the LPG and higher than Coal; Calculated on the same calorific value, the price of natural gas is lower than the price of coal and petroleum. Natural gas is used by civil use, generation, industrial chemicals and industrial fuel etc. it's a good substitute of coal and petroleum. It can take instead of civil coal gas; it can be used as nitrogenous fertilizer instead of coal and petroleum; it can be used as ethylene instead of naphtha; it can be used as the car engine fuel instead of petroleum.
Natural Gas Generator, fueled mainly by natural gas and LPG, is widely used in regions or areas with abundant oil field and natural gas. Global electrical power demand will be 80% higher by 2040, with gas becoming a key energy source for EP generation. The unit starts quickly, be operated easily, with complete set of safety system, and can be as power device and electricity device for oil field and local companies.
2.Core spare parts
Ignition system: American ALTRONIC.
Controller: Comap, Deepsea, Smartgen
Automatic control system: Automatic control plate and ATS fully automatic switch between generator and national grid.
Woodward technology: Adopted Woodward lean burning technology, Woodward or ComAp speed adjusting system
Starting system: DC24V electric motor.
Mixer: IMPCO
Sparking plug: STITT
3.Genset worksite requirements
a. Ambient temperature between -40ºC~40ºC;
b. Relative humidity less than 95%(35ºC);
c. Site elevation not higher than 2500m;
d. For outdoor installation, simple rain shelter is required.
4.Gas requirements
1m from genset's pressure regulating valve
a. Temperature of biomass≤40ºC;
b. Pressure of biomass: 5~20kPa, velocity of pressure≤ 1kPa/min;
c. H2S≤200mg/Nm3;
d. NH3≤20mg/Nm3;
e. Coke tar content≤20mg/Nm3;
f. Impurities particle size≤5μm; impurity content≤30mg/Nm3;
g. Moisture Content of biomass ≤40g/Nm3;
h. Biomass calorific value≥4.2MJ/Nm3.
5.Company Introduction
Since 2008
Factory area over 40000m2
Starff over 260 employees
Technicians over 100 people
website lvhuanpower.en.made-in-china.com
6.Scope of Application
Gas electricity generation, using pure and high-LHV natural gas to provide stable, continous and large amounts of electricity.
7.Advantage
Advanced configuration keep accurate ans stable working condition under high speed working speed
High generalization, easy maintenance, low maintenance cost.
Economical, low operating cost
Reduced the carbon deposition on the wear of the engine cylinder and the valve to prolong the using life of the genset.
Adopt one of the world's most advanced gas control technology, fully available to the characteristics of fuel gas.
Powerful low pressure gas SPI (single point Injection) system used for various supercharger premixed engine.
Suitable for differnt concentration methane and propane, variety of quality gas.
Precise air-fuel ratio rarefied combustion control and Generator speed/load control
Realize lean burn, reduce the intake pipe tempering and improved efficient to reduce the heat load.
8.Requirements For Natural Gas Genset Working Condition
Within 1m from pressure regulating valve of gas intake
The ratio of CH4 in natural gas ≥70%
Pressure of natural gas: 80-200kpa, rate of pressure change ≤ 1kpa/min
H2S ≤ 20mg/Nm3
Impurity particle size ≤ 5μm, impurity content ≤ 30mg/Nm3
Moisture content ≤ 40g/Nm3
9.High Configuration
Ignition system: ALTRONIC(USA)
Starting system: DC24V electric motor.
Mixer: IMPCO(USA)
Sparking plug:STITT
Engine Control System: Woodward(USA), HEINZMANN(Germany)
Electric Control System: ComAp(Czech), Deepsea(UK)
Alternator: Siemens, LEROY-SOMER, Marathon
| Parameter of Natural Gas Generator Set |
| Model Number (Engine Type) |
LHNG500 |
| Brand Name |
LVHUAN |
| Prime Power/Standby Power |
400KW/500KW |
| Rated Speed |
1000/1200RPM |
| Rated Frequency |
50/60Hz |
| Rated Voltage |
400V/230V |
| Phase |
AC 3-Phase, 4 wire |
| Voltage Stability |
≤±2% |
| Voltage transient |
≤±10% |
| Voltage Stable time |
≤1s |
| Heat consumption |
≤11mj/kw.h |
| Lubricant Consumption |
≤1.0g/kw.h |
| Engine Capacity |
71.4L |
| Cylinder Number |
12-V |
| Cylinder Bore |
190mm |
| Stroke |
210mm |
| Starting System |
DC 24V electric motor |
| Cooling method |
water cooler |
| Lubricant method |
Passive and flying lubricant |
| Isolation class |
H |
| Protection |
IP23 |
| Alternator |
Siemens |
| Power Factor |
0.8 lagging |
| Exciting method |
brushless |
| Colour |
your choice |
| Certificates |
ISO 9001:2008, CE |
| Warranty |
1 year or 1000 running hours which arrives first |
| Type |
Open |
| Control system |
Automatic alarm system |
| Size |
6200x2100x2800mm |
| Weight |
12500kg |
10.Certificate
We have CE, ISO14001, ISO9001 and CEC certificate to keep the good quality. Please contact us for more details.
11.Service
(1) 24 hours- technology support service and the promptly reply
(2) Professional engineer team and strong technology support
(3) Customized design based on real situation
(4) Detailed and professional layout drawing, installation drawing and other drawing required by the customers supplied
(5) Engineer service on site
(6) Free training in Factory
(7) Equipment test before delivery
(8) One year guarantee period and lifetime service
(9) Spare parts lifetime supplied
12.Accessories
1) Application scope of the Accessories, such as 12v190, 8v190, 6190, 6135 and other engine types.
2.)All parts were from original factories or professional factories, complete in specification, keep good quality.
Product picture
Audited Supplier 
){kind=link}